Pre 64 Winchester 1894 - Need Help


PDA






chocdog
January 27, 2012, 09:40 PM
I am trying to bring back to life my grandfathers Winchester 1894 in 32WS.
From the SN it was built in 1910 and according to the paperwork, bought in 1911. I have disassembled the gun and cleaned all parts in my ultrasound cleaner. However, I would like to remove the RL cartridge guides//screws and carrier spring/screw so I can finish preping/cleaning the action. Problem is acces to the screws. :cuss: Does anybody know of a special tool or screw driver made to access these screws? All the right angle screwdrivers I have seen are to long to fit. Please help!

If you enjoyed reading about "Pre 64 Winchester 1894 - Need Help" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Peter M. Eick
January 27, 2012, 10:27 PM
I can't help you with your problem, but I can say that you are a better man than I for tearing down your 94 to that level. I was under the impression that you don't want to remove the guides because they are difficult to get properly aligned again.

Do they really need to come out to clean it?

dprice3844444
January 27, 2012, 10:42 PM
http://media.winchesterguns.com/pdf/om/02227_wfa_94_om_s.pdf late 94 manual,might help

http://www.youtube.com/watch?v=WJ4fNow8I7g

http://www.castbullet.com/misc/tdown.htm

http://www.gun-parts.com/winchesterrifle/

google winchester 94 repair also

rcmodel
January 28, 2012, 01:42 PM
There is no need to take the cartridge guide (or guides) out to remove the carrier.

Get yourself a dental pick & Q-Tips & solvent to reach in and clean around the cartridge guides.

They are otherwise best left unmolested.

rc

If you enjoyed reading about "Pre 64 Winchester 1894 - Need Help" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!