Need barrel vise action wrench and 308 finish reamer


PDA






Mountainman1888
January 31, 2012, 09:35 AM
Hey Gents,
I have a Remington 700 chambered in 22-250 and need some tools change the barrel. I have a Shaw .308 varmint contour barrel. It is threaded and short chambered. I was hoping to rent the tools to keep the cost of this build down.

If you enjoyed reading about "Need barrel vise action wrench and 308 finish reamer" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
NCsmitty
January 31, 2012, 10:09 AM
I have used 4D rentals in years past for the reamers, and they always provided new or equal to new cutters that did the job very well. They also have gunsmith tools and accessories, so check with them for the action wrench and barrel vise.
I don't know if you have reamed a chamber before, but a short chambered barrel doesn't require much reaming, and a sharp reamer can go too far in a heartbeat, so just a word of caution. Flush the chamber of chips with air or fluid and check your headspace gauge frequently.
I believe if you use a credit card, you won't need a deposit.

http://www.4-dproducts.com/index.php


NCsmitty

Mountainman1888
January 31, 2012, 08:27 PM
Thanks I will investigate that option. Yes It is my first barrel swap so I'm going to take my sweet time

If you enjoyed reading about "Need barrel vise action wrench and 308 finish reamer" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!