Stripper guide for the Stevens 200 pseudo-Scout I'm building.


PDA






JesseL
February 1, 2012, 12:37 AM
http://i100.photobucket.com/albums/m5/J_M_Lambert/Guns/SteFAL/120131_0003.jpg
http://i100.photobucket.com/albums/m5/J_M_Lambert/Guns/SteFAL/120131_0004.jpg
http://i100.photobucket.com/albums/m5/J_M_Lambert/Guns/SteFAL/120131_0001.jpg
http://i100.photobucket.com/albums/m5/J_M_Lambert/Guns/SteFAL/120131_0002.jpg

Now I need to get some stripper clips and see if it works :o

If it works, I'll duplicate it in steel. I'm not sure how much I can trust those little aluminum nubs, but cutting aluminum is so much less hassle for a prototype.

If you enjoyed reading about "Stripper guide for the Stevens 200 pseudo-Scout I'm building." here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
35 Whelen
February 1, 2012, 01:06 AM
Good job! Does the rear ring extend far enough forward so if a guide were milled into it, it would work?

35W

dprice3844444
February 1, 2012, 01:10 AM
m-14 mags?

JesseL
February 1, 2012, 01:10 AM
Thanks! I don't think it could be milled into the rear ring and still line up with the back edge of the magazine. I could move the magazine back a smidge, but I think it might start running into the rear action pillar.

JesseL
February 1, 2012, 01:12 AM
m-14 mags?

Yep, but fixed and non-removable in this case. That's why I wanted to have the ability to use strippers.

If you enjoyed reading about "Stripper guide for the Stevens 200 pseudo-Scout I'm building." here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!