March 2, 2012, 02:58 PM
I don't need the whole ring, just the bolt and thumb nut. Just bought a rifle and one is missing from the see thru rings shown here: http://www.weaveroptics.com/rings_bases/rings/detachable_top_mount/default.aspx
Any help would be appreciated.
March 2, 2012, 03:17 PM
Is this what I need? Without a pic, I am not sure.
March 2, 2012, 08:11 PM
It would probably be cheaper, and I know it would be a lot easier to just buy a set of rings from Walmart for a few dollars and take the part out that you need.
My personal opinion is that It would be MUCH, MUCH, better to just throw the see-thur mounts in the trash where they belong and take this opprotunity to replace them with a real set of mounts.
Nothing wrong with Weaver mounts. They work as well as anything, just don't look as nice as others, but the guy who thought up see-thru mounts should be forced to use them for the rest of his life as punishment.
March 2, 2012, 08:36 PM
Thanks for the response. I think the see-thrus are only on here for height reasons, as the scope has a 50mm objective, and there are no iron sights. the bell is only 1/2" or so off the barrel. I'll probably stop by Dick's and see if they have the right rings.