Making an SBR, what markings are required?


PDA






sacp81170a
March 21, 2012, 12:30 PM
I'm planning on converting a Sig 5.56 pistol to an SBR by adding a folding stock. I understand that I'm "manufacturing" an NFA item when I do so and must mark the receiver. Is there any particular information that's required, or could I just engrave my initials on the receiver?

If you enjoyed reading about "Making an SBR, what markings are required?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
rjrivero
March 21, 2012, 12:43 PM
Name
City, St

So if you're doing it as an individual:

sacp81170a
Farmington, AR

If you're doing it as a Trust,

sapc81170a Trust
Farmington, AR

Letters need to be 1/16" tall. 0.003" Deep. Available in ATF 5320.8 Chapter 6, and Chapter 7.4. LINK HERE (http://www.atf.gov/publications/download/p/atf-p-5320-8/atf-p-5320-8.pdf).

sacp81170a
March 21, 2012, 12:51 PM
Thanks!

MasterSergeantA
March 22, 2012, 12:17 AM
But you REALLY have to put your REAL name as listed on the approved Form 1.

Swing
March 22, 2012, 12:23 AM
But you REALLY have to put your REAL name as listed on the approved Form 1.

That's what I've always read. That or the name of the Trust if it is registered to said.

If you enjoyed reading about "Making an SBR, what markings are required?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!