May 9, 2012, 08:34 AM
I've recently gotten several totes of older reloading supplies and tools from an estate. Included were 12 - 1# cans of various powders with some full and sealed. Approximate age maybe 30 to 40 years old. Safe to use??? Does powder get less powerful with age or more so? Anyone?
May 9, 2012, 09:07 AM
If properly stored it will be fine. I'm still shooting some powder left over from the 70's. If in metal cans check for rust inside the cans. This will tell you if any moisture has got into the power. The only real way to know if it's change is to shoot it over a crony then compare to new. How does it smell ?
May 9, 2012, 09:33 AM
Just checked a couple of cans. Still has a chemical odor but not nearly as strong as some I bought a few weeks ago (same brand and type). I couldn't really see too well in the can for rust but the outsides of most of the cans are rust free.
May 9, 2012, 09:38 AM
I had the same question a while back, basically was told that as long as no unusuall oder then fine...watch for clumps too. Other then that only thing I would add is just cus it is the same type powder you are using now don't assume you will get the same results.
May 9, 2012, 10:09 AM
Use a light to check in the can to see if rust is there of if any clumps are in there as well. Do not mix this old powder with new powder as they may have been reformulated since the years have gone by.
May 9, 2012, 10:36 AM
Thanks, the thought of shooting some and comparing chrono data is a great idea. Any excuse to go to the range...
May 9, 2012, 01:04 PM
Check for rust. Smell 'em. Pray the open ones contain the powder stated. Sealed should be good.
May 9, 2012, 01:16 PM
Make SURE that the powder inside is what's on the label... if you aren't 100% certain, throw it out (or sprinkle it in the garden).
May 9, 2012, 02:41 PM
And use starting loads and work up
May 9, 2012, 07:53 PM
Whether powder is good is not easily answered unless the powder has gross indications of going bad.
The gross indications are the bitter smell due to NOx, red powder granules, fuming gas emissions, others have said “red gas”. By the time you see this the powder went bad a long time before.
Half of all the surplus IMR 4895 I purchased went bad.
The first 16 lbs, I used up eight pounds quickly. For whatever reason, I pulled the bullets on some of that stuff and found green corrosion on the bases of the bullets.
Similar to these pull down bullets from old US ammunition. Not the horrible one, but the small green spots.
I don't remember what US ammunition these came off, I pulled them decades ago, might have been WWII ammunition that came back from China.
The last eight pounds, it sat around. When I opened the bottle top, it smelled bitter. Red dust flew around.
I gave it to a machine gunner guy. He put it in the laundry room. Passing by the laundry room he tossed soiled shorts at the hamper, but missed. The short ended up on top of the powder bottle. Overnight, acid gas from the bottle ate holes in the shorts!! :what: This freaked my friend and he poured the stuff out over his lawn.
Since then I have had more surplus 4895 powder from a different vendor go bad in the case. Green corrosion on the bottom of the bullets and cracked case necks.
This powder never smelt bitter at all. I shot this powder in highpower matches and it shot exceptionally well, but case necks cracked after firing. I also received “funny” retorts and the occasional sticky extraction. The longer the ammunition sat around the more cases necks would split when fired. In time virtually all of the remaining 700 loaded cases experienced cracked case necks without the stresses of firing.
From what I had read on the internet, which is a repeat of what is said in gun magazines, powder has an “indefinite” shelf life. Remember reading statements to the effect that powder lost energy as it got old, making it essentially benign.
Then I ran into an Insensitive Munitions expert. This IM expert explained that powder deteriorates from the day it leaves the factory.
Nitrocellulose decomposes through the reduction-oxidation process. Called Redox. The expert said “The molecular stability of the functional groups on the organic chain determine the life time of the nitrocellulose molecule.” All ionic compounds, water is the main offender because it is always in air, react with those bonds and accelerates the deterioration of the powder.
The bottom line is that nitrocellulose is a high energy molecule that wants to become a low energy molecule.
Heat accelerates the deterioration/decomposition of powder and the rate is directly proportional to the Arrhenius equation. If you read in the Insensitive munitions literature, you will see that they use high temperature to accelerate aging of smokeless propellants.
Double based powders have a reduced lifetime compared with single base. Double based powders have nitroglycerin (NG) in the grain. Nitroglycerine remains a liquid and it migrates within the grain to react with the NO bonds on the nitrocellulose, increasing the rate of reduction-oxidation reaction. All ionic compounds react with those bonds and accelerate the deterioration of the powder. Rust is bad as ferric oxide is ionic. Water is polar covalent ion and it is ever present in the air.
Because water reacts in a negative way with smokeless propellants, quality ammunition is manufactured in humidity controlled environments. Between 40% and 20% humidity. They don't go lower due to electro static discharge concerns.
The best storage condition for powders is arctic. Cold and dry.
Section from the Propellant Management Guide:
Stabilizers are chemical ingredients added to propellant at time of manufacture to
decrease the rate of propellant degradation and reduce the probability of auto ignition during its expected useful life.
As nitrocellulose-based propellants decompose, they release nitrogen oxides. If the nitrogen oxides are left free to react in the propellant, they can react with the nitrate ester, causing further decomposition and additional release of nitrogen oxides. The reaction between the nitrate ester and the nitrogen oxides is exothermic (i.e., the reaction produces heat). Heat increases the rate of propellant decomposition. More importantly, the exothermic nature of the reaction creates a problem if sufficient heat is generated to initiate combustion. Chemical additives, referred to as stabilizers, are added to propellant formulations to react with free nitrogen oxides to prevent their attack on the nitrate esters in the propellant. The stabilizers are scavengers that act rather like sponges, and once they become “saturated” they are no longer able to remove nitrogen oxides from the propellant. Self-heating of the propellant can occur unabated at the “saturation” point without the ameliorating effect of the stabilizer. Once begun, the self-heating may become sufficient to cause auto ignition.
Heat appears to the be worst enemy of gunpowder
ROLE OF DIPHENYLAMINE AS A STABILIZER IN PROPELLANTS;
ANALYTICAL CHEMISTRY OF DIPHENYLAMINE IN PROPELLANTS
Nitrocellulose-base propellants are essentially unstable materials
that decompose on aging with the evolution of oxides of nitrogen. The
decomposition is autocatalytic and can lead to failure of the ammunition or disastrous explosions.
Heat, as you can see in the report, will age gunpowder
Due to the migration of NG within double based powders, the surface of the grain will become rich in NG even though the total energy content of the propellant has decreased. This will cause changes in the burn rate, and can cause pressures to spike. The surface of nitrocellulose powders also change as the powder deteriorates, and it changes unevenly. This creates conditions for erratic burn rates. Burn rate instability is undesirable and can cause explosive conditions in firearms. In retrospect, this explains the “funny” retorts I experienced and the sticking cases. It is an extremely rare occurrence, but old ammunition has caused rifle Kabooms. When I discussed this with a machine gunner buddy, he said that explained the two top cover explosions he had with old Yugoslavian 8 MM ammo. I think it explains the Garand kaboom in the link below.
The Armed Forces have stockpile surveillance programs but each Service does theirs a little differently. If you want to see all the different tests the military uses to determine propellant characteristics, look at Mils Std 286 Propellants, Solid: Sampling, Examination and Testing to be found at https://assist.daps.dla.mil/quicksearch/.
If you look, you will find aging tests. One common test is for powder to be kept at 65 C (150 F) until it fumes. It if fumes within 30 days it is checked for stabilizer or scrapped.
The Navy expert told me a few ways the Navy samples its powders and propellants. If the powder is outgassing nitric gas (as determined by change of color of methly violet paper in contact with the powder (Methly Violet test, or Talliani test)), the stuff is tested to see how much stabilizer is left. If the amount is less than or equal to 20%, the lot is scrapped.
Scrapping powders and propellants with this percentage of stabilizer appears to be consistent across all services.
Pages 5-11 of the 2003 Army Logistics Propellant Management Guide provide the protocols for testing and subsequent actions for their Stockpile Propellant Program. Basically, all propellant lots are tracked. The trigger for investigation is: "When Master Sample Stability Failure Occurs"
The Navy expert provided 'rules of thumb' concerning when to expect problems with double based and single based propellants. The rules of thumb are: Double based powders and ammunition are scrapped at 20 years, single based 45 years. In his words “These 'rules of thumb' are particularly useful when the protocol fails. The protocol can easily fail when workmanship or good housekeeping measures are not followed during manufacture of propellant and/or rocket motor or during storage of the weapon system components, respectively.”
For the home reloader, if the powder has turned red, or smells like acid, is clumpy, it is way beyond its safe limits.
I am of the opinion that the reason this is not discussed in the popular gun press is because if the shooting community knew that powders had a shelf life, it might effect sales. As we all know, gunwriters are shills for the industry and for decades the shills have been reassuring us that as powder gets old, it becomes benign. I cannot see a reason why industry wants you, the shooter, to be picky about old powders and old ammunition. You might not buy, you might have reservations about buying. It is all about profits you know.
The military does not talk about this, but bunkers and ammunition storage areas have gone Kaboom due to old powder. That nitric acid builds up, creates heat, and the stuff blows up. It blows up inside the case or the shell.
This powder is from a FA 11-1898 30-40 Krag cartridge. Obviously it is bad.
I sent the IM expert the link with this Garand blowup, http://www.socnet.com/showthread.php?p=1344088
and the pictures of my corroded bullets and pulled Krag red powder, and this is what he wrote back:
The red color indicates that the stabilizer is depleted and the redox reaction is degrading the nitrate ester. (I assume this is a single base gun propellant, and the nitrate ester is NC.) Please dispose of this powder and ammo supply before it starts to get warm or self-heat (via autocatalytic exothermic reaction). This stuff can be a runaway reaction and spotaneously explode in storage.
The cracked case necks are proof that the outgassing of NOx is occurring. The pressure build-up is evidently enough to fatigue the metal at a high stress location in the cartridge case (@ the neck bend). You should also see a bulge in the cartridge base (where the firing pin would strike b/c there is a circular joint crimp there between the two metals). This ammo would explosively vent at the crack if you tried to fire it in a gun. Just like the Garand example you sent. Please discard this ammo.
The corroded ammo is the same as above (redox reaction gassing NOx) except this stuff actually got wet too. Water provides a medium for corrosive acid reactions to result. Please discard this ammo.
Lessons learned -
(1) Ammo has a finite shelf life
(2) Ammo can be dangerous
Krag gunpowder was W.A 30 made by Laflin and Rand.
More to read if you wish:
An example of powder that went bad in the can:
vBulletin® v3.8.6, Copyright ©2000-2013, Jelsoft Enterprises Ltd.