[black_powder_Rob]

This was a response to a video from a previous post that is no longer allowed to be posted in. the link for the video is here:
http://www.youtube.com/watch?v=K7JQgqnY6Uk



Nice vid. Wish I had seen it earlier as I broke my de-primer pin on the first case. Their instructions are a little more than lacking when it came to the small case adapter. Well long story short now it is installed and I have some more pins on the way. Quick question though on a few of the cases that I tried before realizing my mistake would the cases still be able to be used (even though they were bent a little) If i re sized them again, this time with the case adapter or would the metal be to stressed?

[scrat]

depends on how bent they are. I have had some cases that were slightly bent and resized them then used them fine. It all depends on how bent they are. if they are severely bent then just toss them.

[black_powder_Rob]

well they still fit in the die with spacer installed. so they are not totally bent, thanks scrat just wanted to make sure before I tried to load them with the rest as this is my first stent into reloading and just wanted to be sure.