[Z_Infidel]

I recently purchased a used 92FS in good shape. The mag release was reversed for left handed shooting. How difficult should it be to switch it back to other side?

Also, the front site dot has been worn off. Does anyone have any advice on how to make it more visible? White-out? ;)

One more thing -- the gun came with a single high-cap mag. What might be the best source for buying additional mags?

Any info would be appreciated - thanks.

So far I like the gun, although I think I still prefer my 1911. :D

[bredda]

Z,

Check out pages 9-10 of the attached to swap the mag release. http://www.beretta.com/PDF/92series.pdf

As to the front sight, a cheap way out is either hi-vis crafting paint from MJ Designs, Hobby Lobby, etc. or standard white acrylic from a hobby shop.

There's people selling high-cap mags all over the internet. Try the gun auction sites like www.gunbroker.com or www.gunsamerica.com. You can also check out the classified section at the Beretta forum (www.berettaforum.net)

[gypsy3]

Changing the mag release is not difficult at all. I popped mine out and moved it to the other side, and popped it back in.
I'm right handed, but my hands are not large. I found it easier to pop the mag release with my middle finger reaching back on my shooting hand, with the release on the right side (Left hander) of the gun. My son, who has larger hands, prefers his in this manner to. Also, I use acrylic paint for sight touch ups too.

[10-Ring]

It's really just a matter of how familiar you are w/ the inner workings & having the proper instructions. I've seen it done and it takes less than 2 minutes (and about 1.5 minutes to get the tools you need :D )

[Acolyte]

CDNN Investments (http://www.cdnninvestments.com/beretta.html) usually has pretty good prices.
The Eagle's can be allright, but also can be iffy. They supposedly have a guarantee. For ten bucks it's worth a shot.
CDNN used to have 'asian military' mags that were getting good reviews, but they may have sold out. Anyway, you can check back there for specials and stuff.

[berettaman]

It's very simple to pop it out.It might take you a while to get it back in the first time.Second time it's a snap.:D

[Kahr carrier]

:what:

[Z_Infidel]

Thanks to everyone for the replies.

I assume the :what: is in reference to my ignorance... Well, before I owned a 1911 I was very familiar with revolvers -- still like them a lot. I have learned a lot and become familiar with the 1911 and its mechanics by shooting a lot, doing research and asking questions. I imagine the same will be true with the Beretta.

[Teufelhunden]

AFAIK, the civilian ones are identical to the military ones, sho this advice will apply: DO NOT lose the washers under the grip screws. They space the grips out far enough so they don't pinch the mag. If you put the screws back in without them, your mag might not drop (as freely) as it once did.

-Teuf

[Z_Infidel]

Thanks for the tip, devildog.

[Logistar]

If I needed more mags for my Beretta, I would order the Asian military surplus mags from CDNN or Cheaper than Dirt. The only caveat is that I would order new springs from Wolff and replace the ones that come with the mags.

The original ones functioned OK but I felt they were a bit weak and was concerned about their useful lifetime. -Still cheap to buy even with a spring upgrade though.

If you want THE BEST mags you might stick with Beretta factory but they will be harder to find probably and cost more.

FWIW - Logistar