Pillar Bed REmington 700 ADL


PDA






pj1985
October 21, 2012, 08:38 PM
I can't decide which bedding to do to my riffle.It's a 300 win mag remington 700 ADL in a synthetic stock? Any pointers in what direction I should go?

If you enjoyed reading about "Pillar Bed REmington 700 ADL" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Plain Old Bill
October 21, 2012, 09:33 PM
Brownell's Acraglas gel is a good beginner's option.

hentown
October 23, 2012, 04:51 PM
Brownell's also sells pillar-bedding kits.

rbernie
October 23, 2012, 05:54 PM
I'm assuming that the ADL gets a different pillar kit than the BDL - no?

hentown
October 31, 2012, 01:13 PM
Probably use the same kit. Have you tried looking up the kit on Brownell's website and reading the product information?

Clark
November 2, 2012, 09:18 PM
I spent about Sept 25 - Oct 8 = 13 days working on a Rem 700 ADL 7mmRemMag.

I took off the original 1960's Hart barrel and wood stock and put on a Shilen barrel.
I cut threads and chamber.
I made some pillars from 1/2" 6061 Aluminum round stock.
I cut the concave radius [1.355" diameter] on the tops of the pillars to fit the Rem 700 receiver using a boring head.
The stock was a 20 ounce High Tech Specialties [Bansner].
Bansner has a video:
https://www.youtube.com/watch?feature=player_embedded&v=ZJ3PJtwHt4o#!
http://www.hightech-specialties.com/stocks.html
I pre compressed the pillars with the action screws.
I used Devcon Steel putty [epoxy].
I wrapped the receiver and stock with surgical rubber tubing and put them under a heating pad until cured.
I made a new recoil lug because the old one was rusty.
My recoil lug had thousands of thickness variation, as I do not have a surface grinder. I got paranoid about that.
So I bought a Holland lug. It has a hole for a pin.
So I drilled a hole in the receiver to pin the lug.
The Holland lug was thicker, so I milled out some extra material from the stock.
I glued a Pine plug in the stock butt.
I screwed a large grind to fit Limbsaver recoil pad to the Pine.
I did not grind the pad, but covered the reveal with a Triad tactical stock pack
http://www.triadtactical.com/Triad-Stock-Pack.html
I left the pull long on the stock, as I do my shooting prone from a bipod.
I shot it at 100 yards but did not finish it in time for hunting.
It consistantly shoots 1" 3 shot groups at 100 yards, which is good for a rifle that light and powerful.
I still need to put epoxy putty on the stock, sand, and paint.

Clark
November 4, 2012, 10:40 PM
http://www.thehighroad.org/attachment.php?attachmentid=174138&d=1351901405

That is a drawing of my pillars.

If you enjoyed reading about "Pillar Bed REmington 700 ADL" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!