Mini-14 Harris Bipod Install Question


PDA






gopackgo
November 12, 2012, 10:28 PM
I just installed a Harris HBRS 6-9 in. bipod on my Mini-14 using the HB14 adapter. I installed as recommended in the Harris instructions, but I end up with a gap between the adapter and the forearm stock. Try as I might, I couldn't get the adapter flush. Am I doing something wrong? The installation seems rock solid, even after multiple test deployments; I haven't taken it to the range yet, so I don't know how it will handle recoil. I have seen some pictures of this bipod installed, most flush, some with a gap. Any advice or comments?

If you enjoyed reading about "Mini-14 Harris Bipod Install Question" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Jaxondog
November 20, 2012, 07:24 PM
Nice looking rifle, but it's a little hard to tell much with those shot's. Maybe a little closer and clearer.

OpticsPlanet
November 21, 2012, 10:50 AM
I sold my Mini last year, but there was a gap with my Harris bipod adapter as well. Still was rock solid, and did not affect the use in any way.

Mark H.

If you enjoyed reading about "Mini-14 Harris Bipod Install Question" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!