930 SPX forend fit


PDA






breakingcontact
November 20, 2012, 05:29 PM
I'm not able to fully thread the mag extension on as only 5 of the 6 threads on the magazine tube are exposed.

I need to figure out where the forend actually makes contact with the metal on the gun and shave off about 1/8th of an inch.

I can either do this inside or modify the outside (front) of the stock where the mag extension meets so the mag extension has a recess to come down another 1/8".

What do you think? Where do I trim?

Yes, I've tried forcing it down farther, checked everything, jiggled and wiggled.

If you enjoyed reading about "930 SPX forend fit" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
C0untZer0
November 20, 2012, 05:41 PM
You can also get help at the Mossberg Owner's forum:

http://www.mossbergowners.com/viewforum.php?f=14&sid=a4aa250559adfd53681054951c1e4004

breakingcontact
November 20, 2012, 06:02 PM
Appreciate the link. I've got a post over there, but no info.

So many guys are having/had an issue with this gun, they replace the spring/follower/extension. If it's the same problem, it's just the gap created by the forend not being fully down stopping all of the threads from being exposed.

If you enjoyed reading about "930 SPX forend fit" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!