[arinvolvo]

ok, i cant remember what # i left off on the last time i posted one of these...but there are TWO things wrong with this picture. 1st one to get both gets a cookie...but not from me, you will have to go find you OWN cookie...the grocery stores usually have them.

http://www.thehighroad.org/attachment.php?s=&postid=840773

[Preacherman]

Well, one is that the rear of the front sight is an edge, not a curve: but it's shown as a curve in the reflection on the knife.

[arinvolvo]

nope, no retouching on the sight.

[StuporDave]

1 - I don't own the gun

2 - I don't own the knife

:D

[PCRCCW]

Its NOT A CZ?????????????????????????? :D

Shoot well.

[Quack]

it doesn't have "Stainless" on the slide.
the "i" in SiGARMS is in lower case
the front sight on a P239 should be (is usually) a "8"

it kinda also looks like it says "P233" instead of "P239"

[Gary in Pennsylvania]

wellllll . . . . . . is Quack correct??

[RobertHankins]

The stamp is offset

[hkusp]

1) The little i in SiGARMS.
2) Slide stop notch too far forward.

[Quack]

it's not a slide stop notch, it's the takedown notch.

[Marshall]

It's really a J frame S&W .357 mag?


:neener:

[hkusp]

"it's not a slide stop notch, it's the takedown notch."


Oops. I'm not a Sig fan and just took a shot at the question.

[Detachment Charlie]

On any Sig the bayonet goes beneath the barrel. Sheesh, anybody should know that! That's where the bayonet lug used to be, pre-ban.

[gbelleh]

The word "stainless" is missing.

The letter "A" in USA is missing.

I just got myself a cookie and it was good!!

[KMKeller]

Never mind.

[Andrew Wyatt]

did you photoshop the Al Mar logo?

[arinvolvo]

Alright folks...quack got half of it, and gbelleh got the other half...good job guys!!

The word "stainless" was shopped off of the slide, and the A in USA was shopped off also.

Enjoy those cookies!!!:D :D :D

[Quack]

forget the cookie, i just had a pizza :)