Colt SAA Grips


PDA






warrennadeau
December 3, 2012, 08:21 PM
HELP
I am trying to make single piece colt SAA grips. I have made the 2 outer panels of walnut but I have no idea what the insert inside the frame is supposed to look like. Is there a plan or design that holds the grips in place when the backstrap is screwed on?
Also how can I best remove the pin that held the original black grips in place? It seems very tight and I don't want to tap it with a hammer.
Any help you could offer would be appreciated.
Warren

If you enjoyed reading about "Colt SAA Grips" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
rcmodel
December 3, 2012, 08:45 PM
Tapping it with a hammer, then with a pin punch, while the frame is supported on a bench block with a hole in it is the only way you will get it out.

I have no plans for the center of a one-peice grip center block.

But all it has to do is be the same width as the grip frame, and leave room inside for the mainspring to miss it while cocked and uncocked.

Should be pretty easy to trace one out on a sheet of paper to make a pattern.

rc

dfariswheel
December 3, 2012, 09:02 PM
Here's as link to Collins Craft's kits.
This shows the general shape of the filler.
He uses pins and glue to hold the parts together, but you can get a good bond by roughening the grips and filler to give the epoxy better adhesion.

http://www.collinscraftgrips.com/kits.php

Here's Tombstone grips kit showing their filler.

http://www.tombstonegrips.com/mm5/merchant.mvc?Screen=PROD&Store_Code=TGG&Product_Code=Colt_116a&Category_Code=Colt

What I did was to use a drill to drill lots of very shallow holes in the grips and the filler. I'd turn the drill so the shallow holes would be slightly undercut.
These undercut holes would give the epoxy "locks" to insure a firm bond.

Jim K
December 4, 2012, 12:59 AM
It is actually not hard. In the old days, those grips were made from a block of walnut, but today, as you have seen, they are usually made using a separate filler. The trick is to make the filler first, make sure it fits OK, then add the side pieces, which need to be oversize so they can be fitted (not all back and front straps are created equal). When you get close, use masking tape to protect the metal while you do the final sanding. And don't forget the top part has to be fitted to the wide part of the backstrap.

Also, make sure you don't glue/epoxy the grips to the back or front strap. :banghead:

Just FWIW, one outfit charges $300 for fitting solid wood grips to an SAA (and that doesn't include shipping the gun).

Jim

If you enjoyed reading about "Colt SAA Grips" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!