Taurus TCP 738 Frame Detail Strip Help


PDA






Spammy_H
December 10, 2012, 12:15 PM
I was swapping out the slide stop on my 738, and knocked out what I thought were the two pins holding the fire control group/block in place. Well, as it turns out, only the front pin was for the fire control group, and the back one was for the sear spring.

As it turns out, I can't get the rear pin back in properly, and think I may have damaged either the sear spring or the hammer spring, but didn't want to go any further until seeing if anyone can offer some help on the detail strip of the frame.

I did some research on line and only found instructions for detail stripping the slide, which is pretty straightforward. Unfortunately, I messed up the wrong half of the gun for those instructions to be of any help.

Thanks if you can help.

If you enjoyed reading about "Taurus TCP 738 Frame Detail Strip Help" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Spammy_H
December 27, 2012, 10:45 AM
bump

If you enjoyed reading about "Taurus TCP 738 Frame Detail Strip Help" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!