[Joshua M.]

What exactly do I need for a "quick" changeover for a Dillon 650...I don't know anything about them, other than my Dad just bought one, and has the .45acp, and would like to get him a .44 mag setup. We both have plenty of RCBS dies, so I won't need a set of those, just everything else that make it so nice. Thanks y'all...- Joshua

[NeuseRvrRat]

you need a caliber conversion kit (comes with shellplate, locator pins, and a powder funnel) and a quick change kit (toolhead, powder die, powder measure, and a toolhead stand).

with those parts, you'll only have to change out the shellplate and locator pins, then slide the other toolhead out and the new one in.

idk what parts your press is coming with, so you may not need to order all that. i don't switch up very often and powder measures are expensive, so i just get a caliber conversion kit, toolhead, and powder die for each cartridge. i use a homemade toolhead stand made of wood.

[Joshua M.]

Thank You.

[billybob44]

http://www.dillonprecision.com/#/content/p/9/pid/23804/catid/2/XL_650_Caliber_Conversion_Kit

^^^This is what you should need for your 650..Bill

[NeuseRvrRat]

sorry, i was thinking 550 (probably because that's what i have) and i forgot all about the casefeeder conversion parts in the caliber conversion kit. you'll need the kit billybob linked to and this for a true "quick change":

http://www.dillonprecision.com/#/content/p/9/pid/23806/catid/2/XL_650_Quick_Change

the casefeeder plate is the same for .45 ACP and .44 mag

[Magnum Shooter]

Conversion Kit

http://www.dillonprecision.com/content/p/9/pid/23804/catid/2/XL_650_Caliber_Conversion_Kit

Quick Change, not a must have but nice

http://www.dillonprecision.com/content/p/9/pid/23806/catid/3/XL_650_Quick_Change