lubrication question..,


PDA






w9trb
January 13, 2013, 05:51 PM
I am getting ready to reload a bunch of 6mm Remington. My question is about lubrication of the cases. So, once I have rolled the cases on the pad and put them through the reloading procedure, how do I remove the lube? It seems to me that any trace of lube should be removed before firing the ammo or am I overthinking this stuff.

If you enjoyed reading about "lubrication question..," here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
sean eady
January 13, 2013, 05:55 PM
Media tumbler for about 30 minutes after cases have been sized. Then load after tumbling. If they are already loaded then I don't have anything for you on that one other than wiping by hand. Some say its ok to tumble loaded rounds , but I am not one of them.

oldpapps
January 13, 2013, 05:57 PM
I use the old fashioned RCBS or LEE lubing grease. Others use spray on stuff and still others use wax.

After I size and deprime, I run my brass in a water/dawn soap/steel pin mix in my tumbler. It cleans the primer pockets and in-sides of the cases. A rattle tub would clean as well. If you are only dealing with a very few cases, a paper towel will do.

w9trb
January 13, 2013, 06:15 PM
Thanks for the quick responses! I will get a tumbler and some media. I will continue to hand wipe each one, until I get better set-up. Thanks again.

jwrowland77
January 13, 2013, 06:45 PM
I've heard that you can put them in the tumbler after they are loaded for a short time (10-15 min), but I have never done it myself. I've read several threads where people have done this.

NeuseRvrRat
January 13, 2013, 06:50 PM
perfectly safe to give them a short tumble after loading. 15-20 mins is long enough to remove lube.

Ifishsum
January 13, 2013, 06:51 PM
I always wipe them off - I don't like tumbling deprimed cases because media in the flash holes causes more work than hand wiping. Once they are primed I would worry about primer contamination (also possibly blocked flash holes), and I'm just not comfortable tumbling loaded rifle ammo.

Pacsd
January 13, 2013, 07:00 PM
I use the RCBS lube, pad and lee trimmer in a shell holder for trim length with a battery operated drill. After resizing I simply give em a quick spin with a paper towel wrapped around it.

BYJO4
January 13, 2013, 10:08 PM
I also prefer to just wipe the lube off.

gamestalker
January 13, 2013, 11:42 PM
I know some don't lube the inside of the necks, but I very lightly lube the inside and outside of the necks. I feel it reduces the odds of sticking a case in the die, and it also reduces the amount of stretch and chatter when the expander button is being pulled out. But thats me?

GS

If you enjoyed reading about "lubrication question..," here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!