Tumbling Media


PDA






lightman
January 15, 2013, 07:26 PM
Someone here posted about using corncob from Drillspot. I can't find that post. Doe's anyone remember what grit is common for brass polishing? Thanks Lightman

If you enjoyed reading about "Tumbling Media" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
RustyFN
January 15, 2013, 07:28 PM
I use the 14/20 and it's pretty fine. I have seen where others use the20/40 and don't have any problems.

mdemetz
January 15, 2013, 07:43 PM
With the 14/20 I occasionally get one stuck in the flash hole. Very easy to poke out.

Blue68f100
January 15, 2013, 08:24 PM
I use the finer 20/40 corncob. It's small enough to fall through primer holes. It polishes the brass very bright if you run it a couple of hrs.

lightman
January 15, 2013, 09:22 PM
Thanks for the replys,everybody. Going to order some and do some loading over the next few months. Lightman

MR835
January 16, 2013, 07:14 PM
Hello Lightman: I use Walnut shells for cleaning 18/40 grit. and 20/40 grit
corncob for polishing. I also add Flitz polish to both. The Brass is shiner than new. The Flitz puts a coating on the Brass it will not take your finger print and very slick. very little lube needed for resizing.

Take Care, SAFE SHOOTING ALWAYS.

MR835 IS GONE

lightman
January 20, 2013, 12:16 PM
Just a follow-up. I ordered from Drillspot on-line the other night. The stuff was on my doorstep two days later, with the standard free shipping. It looks good too! I was impressed! I'm not connected with them in any way, just want to add a good word, when its justified. Thanks to those that responded to my post, too! Lightman

If you enjoyed reading about "Tumbling Media" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!