self removing primer??


PDA






mattm0691
January 22, 2013, 05:07 PM
Had today off so I visited the range this morning. I was firing some 147 grain underwood through my Taurus 92, when after one shot I felt something VERY hot land on my left (non-firing) hand. After very rapidly putting my pistol on safe and benching it, I looked in my hand and found.. a primer. Apparently it ejected itself from first the brass and then my pistol. Is this a very bad thing? As in, should I not fire the rest of this ammunition? (I stopped shooting it after this incident).

If you enjoyed reading about "self removing primer??" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
ku4hx
January 22, 2013, 05:41 PM
Fresh factory or reloaded/remanfactured? I've seen this happen a couple of times. Primer pockets were enlarged from too many firings. And of course varying manufacturing tolerances can cause too large a hole even in new unfired cases.

If it's fresh and not reloaded ammunition, contact the manufacturer.

mattm0691
January 22, 2013, 05:59 PM
yeah it was brand new from the factory

Jenrick
January 22, 2013, 07:39 PM
It does happen even on factory ammo, that's why military ammo has the primer pocket swagged to prevent it from being knocked out. Tolerances misaligned in your case, so that the primer pocket is large and the primer cup is small.

-Jenrick

Drail
January 22, 2013, 08:28 PM
Some brands of primers are a very loose fit in some brands of cases. I have never understood why everybody can't seem to get on the same page with components but there are a lot of variations.

chris in va
January 22, 2013, 11:19 PM
I can't quite get a bead from their website, but it's implied the rounds are reloaded ammo.

The Lone Haranguer
January 22, 2013, 11:34 PM
Did the report and recoil seem greater than normal? Because a primer pocket so loosened that the primer falls out is a sign of a seriously overpressure load.

mattm0691
January 23, 2013, 06:25 AM
Well yeah the recoil was pretty stout on every round. They are marketed as +p+

Jim Watson
January 23, 2013, 10:31 AM
A blown primer is very undesirable.
It might be from excess pressure or a worn out case... or some combination.

Underwood is very proud of their heavily loaded ammunition and since this is cataloged as new production and +P+, it is likely they have a bit too many plusses in their powder measure.

There is no standard for +P+, it is whatever they think the guns will stand. The hundred fps over their mere +P. for which there is a SAAMI specification, does not come for free in terms of chamber pressure.

Drail
January 23, 2013, 11:05 AM
Wow. I have seen loose primers and blown primers but I have never seen one that ejected separately from the case. Just one more reason to handload.

If you enjoyed reading about "self removing primer??" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!