One piece scope mount&base for bolt action?


PDA






jlewis406
February 3, 2013, 06:20 PM
I have no idea if such a thing exists...but I am looking for a one piece scope base with integrated 30mm rings for a Remington 700 Short Action.

What I am thinking of is something like the Burris PEPR or the KAC one peice scope mount I have on my AR, but designed for a bolt action. So instead of channels for the rails the base just screws into the action like a traditional scope base, but has integrated rings. I am just looking for something will less points of failure. Thanks gents.

If you enjoyed reading about "One piece scope mount&base for bolt action?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
fgr39
February 3, 2013, 06:25 PM
look at the DNZ gamereaper setup, not sure if they have 30mm, but they are great.

119er
February 3, 2013, 09:05 PM
Here is what I have been looking at.....

http://nightforceoptics.com/accessories/direct-mount/

jlewis406
February 3, 2013, 09:39 PM
Man, I am thankful for the power of the internet. That's pretty much what I am thinking of!

Loc n Load
February 4, 2013, 11:14 AM
I use a GG&G one pc mount with throw levers on several of my rifles, these mount on any 1913 rail...which can be obtained for most rifles....I have used the GG&G mount for several years on several rifles and carbines that have seen a lot of hard use.....they maintain their zero when taken on and off and they are built like a tank.....I like the throw levers on AR's or even on some of my bolt guns, so I can swap out optics in just a couple of seconds. They make them in both the 30mm and the 1".....Brownell's and Midway both carry them.

ilmonster
February 4, 2013, 03:08 PM
A company named Spuhr makes one piece base/ring mounts - very nice ones.

ilmonster
February 4, 2013, 03:10 PM
Actually, these need to be mounted on an existing picatinny rail - not what you're looking for.

jmr40
February 4, 2013, 03:16 PM
You can spend more, but won't beat these.

http://swfa.com/Remington-C2634.aspx

NeuseRvrRat
February 4, 2013, 03:46 PM
DNZ Products makes an excellent mount. they are rock solid.

ThirtyOughtSix
February 4, 2013, 04:25 PM
+1 for DMZ Gamereapers. They're all I use.

jlewis406
February 5, 2013, 01:17 AM
I think I am going to go with the DNZ mount. I do love GG&G. When I lived in Tucson I could just call them up and tell them what I needed and it would typically be built and ready by the end of the day or the next morning.

If you enjoyed reading about "One piece scope mount&base for bolt action?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!