February 24, 2013, 02:49 PM
Looking for a Gunsmith/machine shop in socal.Have a 1858 Pietta i want to convert to a Kirst cylinder.
February 27, 2013, 04:26 AM
I'm in SoCal and have a decent machine shop.
I would have to see your project to better understand exactly what you need done though.
February 28, 2013, 11:22 AM
If you have a modicum of mechanical aptitude, a vise, some files, wet/dry sandpaper, duct tape, cold blue, hacksaw, and a Dremel tool, you can do it yourself. I did one last year.
I used duct tape to protect the finish while I worked on it.
Kirst includes a paper template that you affix to the inside of the frame with rubber cement, to guide you when cutting the loading port. The frame is pretty soft steel. I used a sanding drum and a grinding wheel to cut the loading port.
After polishing with increasingly finer grits of wet/dry sandpaper, Birchwood Casey cold blue was used to finish the metal.
I also added a Remington factory-style ejector, which required a slot cut in the loading lever.
It came out nicely and shoots well.
This was the first such conversion I did. I took it slowly, putting in about 8 hours over the course of a weekend. It would probably take less time if I do another.
vBulletin® v3.8.6, Copyright ©2000-2015, Jelsoft Enterprises Ltd.