Eezox...using in the barrel


PDA






BBush
March 8, 2013, 08:03 AM
I just wanted to make sure that there was no problem with using Eezox gun oil in the barrel of a gun. As I understand it, the dissolvent in the spray evaporates and leaves behind a protective "waxy" layer that serves as barrier that prevents rust. I just wanted to make sure that this "waxy" layer does not affect the accuracy of a new rifle. Of couse, I would run a cleaning patch through the bore before I shoot it, but I just wanted to make sure that there was no problems with a change in the effects between the rifling and the bullet like some of the moly lubricants can cause. Thanks for any comments back on this issue.

If you enjoyed reading about "Eezox...using in the barrel" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
beag_nut
March 8, 2013, 03:52 PM
Since when does a molybdenum disulfide lubricant have any effect on rifling? (except maybe make the rifling last a little longer)

And aren't your bore swabs harder than the "waxy" coating?

OilyPablo
March 8, 2013, 04:08 PM
I use it all the time in barrels. Not a problem.

Naturally you should never shoot a gun with a barrel full of oil. :D

Also I use Corrosion-X with great success, which is a bit thinner.

Legion489
March 8, 2013, 04:28 PM
Love the stuff. It cuts down on leading, easier to clean barrel, great lube.

If you enjoyed reading about "Eezox...using in the barrel" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!