chamfer and boat tails


PDA






shoots45s
March 14, 2013, 06:32 PM
Is it necessary to chamfer the casing if the bullet is a boat tail?

Thanks,

If you enjoyed reading about "chamfer and boat tails" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
gamestalker
March 14, 2013, 06:37 PM
It's necessary to chamfer if you've trimmed, but I've always used a light chamfer just to ensure no shaving during seating.

GS

GLOOB
March 14, 2013, 06:39 PM
IMO, you should chamfer after you trim. Even for boat tails. Unless you use a flare die, like a Lyman M die.

But between trimmings, no. Not with boat tails. Might be very helpful to do a light chamfer for some flat based bullets, though.

OldTex
March 14, 2013, 06:54 PM
I think originally chamfer tools were made solely to remove any burrs that might have been created during trimming. For the most part that is still true today. But some of the newer high-dollar bullets like some from Berger have an extended boattail design, sometime called VLD (very low drag) bullets. You can buy special chamfer tools that are specifically made to put a long gradual chamfer on the inner neck wall so that these expensive little babies don't get bunged up during seating. If I was loading these fancy bullets that can cost upwards of $1+ each into brass that hasn't been chamfered, I'd use the tool whether I had just trimmed or not.

And point of order. This is not aimed at the OP because I've seen a sudden surge in this at every gun forum since so many shooters are getting into reloading. A CASING is what you stuff sausage into. A CASE is what you stuff gunpowder into. That is all.:)

shoots45s
March 14, 2013, 07:07 PM
Thanks for the info.

And thanks to OldTex, no offense taken, I stand corrected.

My pet peeves include many news reporters talking about high capacity clips, rather than magazines, and just showing their ignorance.

And on TV, guns that don't show recoil. semi autos that don't lock back when empty and continue to go click, click, click. Geez Hollywood, get a clue.

And on Alaska State Troopers, I saw one trooper disarm someone, rack the slide and then drop the magazine. He should know better.

Otto
March 14, 2013, 07:08 PM
I use a VLD chamfer tool. It's 22 as opposed to the common 45 chamfer. Lyman, RCBS and K&M now make them.

Geno
March 14, 2013, 07:09 PM
I always have. Is it needed? Perhaps not. But I still always have done so.

Geno

45lcshooter
March 14, 2013, 09:27 PM
Chamfer everything, makes all bullets, flat bottomed, and boat tailed go in sooooooooo much smoother.

Chamfer and deburring is a necessary point to reloading.

beatledog7
March 14, 2013, 10:14 PM
I agree with 45lcshooter, a little chamfer makes every bullet easier to seat. It only takes 2-3 seconds per, so I do it on every case every time, whether it was trimmed or not.

If you enjoyed reading about "chamfer and boat tails" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!