Sling studs 982


PDA






BullFrawg
March 17, 2013, 01:14 PM
Hey all, I just bought a Hawk 982 shotgun, and I am looking for advice on what sling studs I need to get for it. The back one is just a standard machine thread, but the magazine cap is confusing me. There is a hole in it, but it isn't threaded. Can I just get a standard stud and put a nut behind it, or will that interfere with the magazine follower? Thanks in advance.

FYI, the 982 now comes with a plastic trigger guard.

If you enjoyed reading about "Sling studs 982" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
rcmodel
March 17, 2013, 03:19 PM
Since it appears you have zero clearence inside the cap?

Your best bet might be one of these.
http://www.midwayusa.com/product/633381/yankee-hill-machine-threaded-sling-swivel-stud-steel

Or this.
http://yhm.net/index.php?main_page=product_info&cPath=2_4_51&products_id=154

Drill & Tap threads in the cap to fit the adapter or solid stud, then grind flush on the inside of the cap.

Then mount the adapter with blue or red lock-tight.

rc

Fred Fuller
March 17, 2013, 03:34 PM
Some of the Norinco/Hawks come from the factory with a shortened machine screw stud in the mag cap, backed by a washer and nut, held in place with a dollop of something like thread locker. Any similar approach should work...

BullFrawg
March 17, 2013, 03:38 PM
Thanks. These posts are very helpful.

If you enjoyed reading about "Sling studs 982" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!