Lr 308


PDA






wjohn432
April 18, 2013, 09:18 PM
would like some help on easy trigger job for my ar-10,have done 15 min jobs on ar15,not sure it can been done on ar10,any advise will be helpful.

If you enjoyed reading about "Lr 308" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
mtrmn
April 19, 2013, 10:27 PM
If you've done AR15 trigger work, there will be no problems. They are the same parts as long as you have the regular single stage trigger.

velocette
April 20, 2013, 06:26 PM
The LR 308 series uses the same trigger parts as the .223 AR rifles.
The only difference is that the .308 triggers use a heavier hammer spring to move the heavier firing pin of the .308 AR.
A work of caution. Most factory AR trigger parts are made of surface hardened steel. That is, the sear and hammer hook have a thin layer of surface hardened steel so that they will not wear out quickly. If you polish or stone through that (very) thin layer, you will have a hammer hook or sear of soft steel that will not last long or be safe.

(There is a reason that Geissele triggers are expensive. They are really worth it!)

Roger

If you enjoyed reading about "Lr 308" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!