file a bevel on takedown pin


PDA






Mark K. C.
May 22, 2013, 12:02 AM
will fileing a slight bevel on the takedown pin on a Taurus TCP 380 have any effect to the integrity of the pistol? Once removed there is a retaining spring in the hole that is a bear to get the pin past. I'm thinking a small edge on the pin, just enough to get past the spring, will be the ticket to this problem.

If you enjoyed reading about "file a bevel on takedown pin" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
john323
May 23, 2013, 04:17 PM
Should not be a problem.

rcmodel
May 23, 2013, 10:22 PM
If you are talking about the very end that goes out the other side?

I agree.
Just don't bevel it enough you lose frame support on that side.

Don't bevel the notch the spring rides in to keep in in the gun however.

rc

If you enjoyed reading about "file a bevel on takedown pin" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!