For about 1000 rounds my 450 primed and functioned flawlessly for 45 ACP, using Large Pistol Primers.
Then it stopped.
I simply drew the handle back to retrieve a primer- and no primer appeared in the cup.
I removed all of the pieces, and the red primer keeper end in the feed tube was smashed.
I replaced it with another rep tip, reassembled, refilled, tried to retrieve a primer and observed........
It appears that the primer is suddenly too high, or the lips of the keeper are suddenly too low, as the lip of the primer cup strikes the primer keeper broadside.
I've reassembled it three times with the same result.
If you enjoyed reading about "Dillon 450 Primer tube problem." here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
July 16, 2013, 05:35 PM
I have a 450 and took the primer tube assembly apart after reading your post and can't understand what your problem may be. I need to push mine in firmly when I assemble it for it to work properly. It needs to be seated all the way down. Other than that there isn't much to it. Hope that helps you.
July 16, 2013, 05:39 PM
186389Here maybe this will help.
July 16, 2013, 06:03 PM
Ok, if that cutaway is any indication, I think I have a major problem.
My primer keeper is extending beyond the depth shown in the diagram- about a full primers' depth out of the asembly.
I'm trying to get a pic- plz hold the line !
July 16, 2013, 06:06 PM
Best I could do.
July 16, 2013, 06:22 PM
In the cut away, the "plastic expandable lock ring" might be where your problem is. I just remembered that many years ago I replaced that with something I fabricated. That is why I must push mine down firmly. I never had a problem after that. I have had mine since about 1983 and forget stuff I did over the years. That lock ring squeezes and holds the tube in place.
July 16, 2013, 11:12 PM
There is a set screw that holds the reprime punch in the slide. If this comes loose or the punch breaks ( I have had both occur) the condition you describe can occur.
July 16, 2013, 11:14 PM
*takes a look at that*
Just out of curiosity- is the primer keeper supposed to extend into the primer slide area- or stay up in the primer magazine ?
July 16, 2013, 11:30 PM
Best as I can get showing the problem.
You can see the shadow of the cup on the primer keeper- thats the specific amount it seems to be jamming into it, as opposed to going underneath it.
The set/support screw on the primer cup is as firm as can be.
July 16, 2013, 11:44 PM
Ooops - my initial response to blarby was a brain-fried one. :D
July 16, 2013, 11:46 PM
Lol- its OK :D
So, the primer keeper tube is supposed to protude in that fashion ?
July 17, 2013, 01:28 AM
*blarby goes into acquire mechanical knowledge mode*