bullet lube


PDA






deadeye dick
August 12, 2013, 12:39 PM
Just bought a new Ruger Blackhawk in s/s 38sp-357 mag. I picked up some lead bullets at the gun show and the groove is dry ( no lube) The bullets seem to be coated. do they have to be hand lubed? Thanks.

If you enjoyed reading about "bullet lube" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
243winxb
August 12, 2013, 01:13 PM
No, not if coated. Alox type lubes will cover the whole bullet. Lee makes tumble lube molds for the lube. Other type cast bullets, with just 1 large groove may work ok with Alox. There are also other coatings used. http://i338.photobucket.com/albums/n420/joe1944usa/castbullets.jpg

RPRNY
August 12, 2013, 01:38 PM
This is a subject on which you will hear many passionate, informed, ignorant and near fantastical opinions. Enjoy.

Provided the bullet diameter is a good fit to your bore, with driving bands sized to get into the rifling grooves and bullet body and ogive suited to bore size, tumble lubed, plain based bullets in .38 Special at speeds up to @ 1200 fps should perform well. For .357 or speedier Gas Checks and groove lubing may suit better.

PO2Hammer
August 12, 2013, 03:26 PM
I picked up some lead bullets at the gun show and the groove is dry ( no lube) The bullets seem to be coated.
Do they look like this lead bullet from Speer?
http://media.midwayusa.com/productimages/880x660/primary/258/258551.jpg

Walkalong
August 12, 2013, 03:37 PM
Or these pre-lubed Hornady bullets?

http://www.midwayusa.com/product/382348/hornady-bullets-38-caliber-358-diameter-158-grain-lead-semi-wadcutter-box-of-300

If they look like the ones 243winxb posted without lube in the lube groove, you need to lube them.

If you enjoyed reading about "bullet lube" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!