Winchester 320 bolt removal.


PDA






lobo9er
August 26, 2013, 09:30 PM
Anyone know anything about the model 320? The bolt doesn't seem to come out by just pulling the trigger like most bolts I have used. There is 2 screws on the side of the receiver but I thought it looks like a place to install a peep sight. Any comments or suggestions would be great. Thanks in advance.

If you enjoyed reading about "Winchester 320 bolt removal." here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
JT-AR-MG42
August 27, 2013, 01:55 PM
I don't have a manual for mine either.

Bolt removal is by cocking and closing the bolt on an EMPTY chamber.

Off safe. Pull the trigger (this will fire the rifle), and while holding the trigger back, open the bolt and pull it out the rear.

To re-install, hold the trigger back firmly with the safety off and insert the bolt.

JT

lobo9er
August 27, 2013, 04:40 PM
You the man JT will try that tonight.

lobo9er
August 27, 2013, 09:13 PM
yep thanks for the tip. now i can get the ole gun proper clean :)

If you enjoyed reading about "Winchester 320 bolt removal." here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!