The simple things......


PDA






119er
December 6, 2013, 11:14 AM
I had been looking at the die storage box by MTM for a while and decided to get one. Partly because I have an obsession with organization, and partly because I am cheap to a point. I bought it to consolidate my high volume calibers(.223/.308/.30-06) to one location and it performs this task well with one small exception. The Redding Competition seater die, .30-06 in my case, has no chance of fitting in upright(MTM states this themselves). My Forster Benchrest seaters for .223 and .308 fit if I run the lock rings up all the way. I use the same dies for single stage and progressive, so adjusting them has never bothered me enough to buy a second set of dies anyway.

On the cheap part, I pull the decapping assemblies to remind me to switch my carbide buttons around. At ~$30 a piece I will go through the small hassle to switch them around! .30 cal is the more difficult switch as I have to change over the sizing ball to different decapping rods.

Anyway, for about $15 it makes me happy. It also eliminated all the cumbersome die boxes. I'm thinking of another one for my milsurp calibers too.

If you enjoyed reading about "The simple things......" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
If you enjoyed reading about "The simple things......" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!