[WonderNine]

Is there a source for replacement parts like mag springs?

[jar]

Well, the mags are so cheap that it is almost cheaper to just buy new ones.

[bpisler]

I not sure but check wolff springs,
they seem to have a little bit of everything.

[WonderNine]

Well, the mags are so cheap that it is almost cheaper to just buy new ones.

Well, I was hoping you could buy a new spring for cheaper than $20. I am mainly worried about when the supply runs out. Thanks for the Wolf Springs suggestion, you're right, they might have a spring that would work.

Does anybody know though who actually makes the KRD mags? Is KRD a company? Maybe replacement springs can be ordered from them? I'll check into that as well.

[Bartholomew Roberts]

Haven't seen a source for mag springs for the KRD. Regular Hi-Power springs will work in them; but may not work as well.

I wouldn't worry about it too much since it looks like the mag body will self-destruct long before the spring goes.

[JohnBT]

KRD is based in Argentina and made mags for the FM HiPower as well as the S. African military and police. I haven't looked for springs yet. It was hard enough loading the HiPower mags to capacity in the first place. So far no problems with mine at all.

John

[WonderNine]

KRD is based in Argentina and made mags for the FM HiPower as well as the S. African military and police. I haven't looked for springs yet. It was hard enough loading the HiPower mags to capacity in the first place. So far no problems with mine at all.

That's another thing. Everyone is complaining about these magazines being so hard to load. Honestly, I haven't found them to be any more difficult than a typical factory or Mec-Gar magazine.

[Stephen A. Camp]

Hahahahahha! That's good. Had yours been like the ones I got, you'd really appreciate the way yours are. I've alwasy seen little need for magazine loaders, but was danged happy to get one with those. I don't know this at all, but perhaps the springs have been changed in subsequent lots?

Best and good shooting.