[sevenpoint62mm]

Can't find where this goes.

[alamo]

See if this helps. First one is for the P-11 / P-32, 2nd one is P-32. Only real difference is between the P-32 & P- 3AT is the lack of the slide stop on the P-3AT.


http://1bad69.com/keltec/disassembly.htm#field_strip_reassemble

http://www.gunsmith.fuselier.com/P32assembly.html

[sevenpoint62mm]

Err, these are what I was going from. However theres no picture or walk through of the hammer block pieces. :( Going nuts as I've already F&B and ready to do a bore burn-in.

These thing makes a Mark 2 look easy to reassem.

[alamo]

Ask over here. I took the frame out of my P-32 once but it's been too long for me to recalll exaxtly how it goes.

http://www.ktog.org/vbulletin/

Does this picture help? Part #272

http://kel-tec.com/p3at_parts.htm

[mini14jac]

The first time I took a hammer block out, I had the same problem.
I ended up putting all the parts in a Baggie and sending them back to KelTec.
I had to pay for shipping, but there was no charge for the repairs.

I've since learned to do it myself, but it is a bear to figure it out.