Does Voloquartsen MK2 trigger have takeup adjustment?


PDA






toolmaker
July 5, 2004, 10:14 AM
I have a good crisp letoff with minimal overtravel on my two MK2 bull barrels. I'd like less takeup though. Can the Volquartsen be adjusted for this? Can any aftermarket trigger for my MK2s be adjusted for this? Thanks.

If you enjoyed reading about "Does Voloquartsen MK2 trigger have takeup adjustment?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Dienekes
July 6, 2004, 01:19 AM
You might ask the tech rep at Brownells. I recently put in a Volquartsen kit into an older pre-Mk. II standard auto, but installed the Clark steel trigger which I preferred to the Volquartsen. The trigger pull is much improved--probably the best of several of these guns including a Mk 514 Target.

I suspect that the reset is going to be about the same length as the disconnector needs a fair amount of travel for its function.

Graystar
July 6, 2004, 01:59 AM
I suspect that the reset is going to be about the same length as the disconnector needs a fair amount of travel for its function. This has been my finding as well. I believe that the Volquartsen trigger's internal demensions are the same as the stock trigger ("internal" meaning the part that is inside the frame.) I don't think you can make that trigger behave like, say, a S&W M41 trigger. It's a design issue.

Matt-man
July 6, 2004, 02:40 AM
The Volquartsen trigger does not have a pre-travel adjustment, just an overtravel screw.

Marvel Products has a trigger with both pre-travel and overtravel adjustments.

http://www.marvelprecision.com/newtriggers.htm

Penforhire
July 6, 2004, 05:55 PM
What he said! I noticed no difference in VQ take-up versus stock either.

If you enjoyed reading about "Does Voloquartsen MK2 trigger have takeup adjustment?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!