1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

03 springfield ok to shoot?

Discussion in 'Rifle Country' started by 351 WINCHESTER, Nov 5, 2008.


    351 WINCHESTER Senior Member

    Mar 19, 2007
    I have an 03 Springfield serial # 830xxx (double heat treated). Made in 1918. Someone sporterized it and did a very nice job. I shot 5 rounds of remington 150 gr. ammo and checked each fired case for problems. None were found. I would like to use this rifle for hunting and I'm looking for feedback as to the strength of the action and things to watch for.
  2. marsche

    marsche New Member

    Aug 5, 2008
    The 'low' number Springfield 1903 rifles are serial numbers 800,000 and below. The low numbered rifles were accused of have brittle receivers. You should have no more concern firing your rifle than you would any other rifle. I have several 1903 Springfield rifles and they shoot very well.
  3. lencac

    lencac Participating Member

    Sep 13, 2007
    I'm sure that rifle is unsafe and in an effort to make sure you remain safe I strongly suggest you send it to me so you can't hurt yourself with it :evil:
  4. Slamfire

    Slamfire Mentor

    Dec 29, 2006
    I recommend that you replace your 60 + yr old mainspring with a new Wolff. I recommend using the 20 pounder mainspring and nothing heavier.

    When you replace the mainspring, you will notice just how weak it has gotten over time.

    What a new mainspring will do is quicken the firing pin strike, crispen the two stage trigger pull, and it may improve accuracy. I shot a ten shot group in a 03A3 with the original WWII mainspring, replaced it, and the next group was significantly better. I believe a snappy mainspring makes a difference. It will certainly reduce the chance of a misfire in cold weather.

    The trade off will be a slightly heavier bolt lift and the trigger pull weight will increase. Neither of which were a bother in my rifles. I did swap cocking rods around to get the lightest bolt lift possible.

    You did not include a picture, so I don't know the sights you have, the safety, etc.

    Even though this is a double heat treat receiver, that does not mean it is made of "uber" materials. Rather it is made of steel that today, is considered adequate for low strength fasteners. Check Matweb on this. http://www.matweb.com/search/DataSheet.aspx?MatGUID=4c43fd8ed4454e2d9301c408e80eab18 So don't try to magnitize this action. Shoot standard loads, use good brass, and all will be well.


    SPRINGFIELD 1903 - All Modifications

    BLITZSCHNELL Load-rated striker springs

    Factory - Reference Only.: 16 Lb.
    Ratings available.................: 20, 24, 26 and 30 Lb.
    Stock No. 648xx.....$ 8.29 ea

Share This Page