1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Anyone ever port their Glocks? If so, who did it

Discussion in 'Handguns: Autoloaders' started by twinhairdryers, Jan 5, 2008.

  1. twinhairdryers

    twinhairdryers Well-Known Member

    Has anyone had an outside shop port their glocks? If so, who did you use, what was the cost, turnaround time, and results of their work?

    I find it curious that there a few places that just go with a simple 3 round hole pattern through the slide and barrel in line with your shooting line of sight. Others due closer to the factory "C" series models with the V formation slots. It seems to me the slots would be better, keeping flame and gas out of your direct line of sight. Anyone have the straight line holes done and are OK with them?

Share This Page