1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Benchmade question.

Discussion in 'Non-Firearm Weapons' started by Coop45, Jan 14, 2013.

  1. Coop45

    Coop45 Well-Known Member

    After the post office sent my new Benchmade on tour of Texas, it's finally in my hand. On the backside of the blade it says.....First Production 12 of 1000

    What is the deal on that?
  2. dubya450

    dubya450 Well-Known Member

    Its a first production lol. One you should hang on to. What model is it? I just picked up a new Benchmade Sibert MPR for $145 normally $260 and i really like it. My 4th Benchmade
  3. Atbat82

    Atbat82 Well-Known Member

    I loved my benchmade (Pardie 5330). Until I lost it... Been using an Al Mar since, great knife, but so much heavier than my Pardue was...

    Sent from my iPhone
  4. Coop45

    Coop45 Well-Known Member

    It's a 470 Emissary.
  5. Il Duca

    Il Duca Well-Known Member

    The first production runs are usually limited to 1000 pieces and sometimes have different materials or color options than the following standard production models.
  6. jonnyringo

    jonnyringo Active Member

    I have the big and small Snody made by Benchmade (limited run). Awesome knives.
  7. Missionary

    Missionary Well-Known Member

    Sounds like a keeper.
    I have an older one that has been around for about 13 years. Cannot remember the model name or #. Clip point balde is 3 9/16" partial serated with Titanium handles. 4 hex head bolts hold it together. Handle is 4 3/4" with a lanyard hole. Very good steel in the blade. Mike in ILL

Share This Page