1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

CZ75 sp01 mini trigger job

Discussion in 'Handguns: Autoloaders' started by Bazooka Joe71, Oct 24, 2006.

  1. Bazooka Joe71

    Bazooka Joe71 Well-Known Member

    I just recently purchased a CZ 75sp01, and the trigger is a bit gritty...I was planning smoothing out the sear, Ejector and Trigger Bar from any of the machining marks made by the factory. I haven't really ever had to do this before, so I was just wondering what would be the best thing to use when smoothing them out.

    Pardon my ignorance, but if its sand paper, then how rough should I use.

    Thanks in advance guys/gals!
  2. The-Fly

    The-Fly Well-Known Member

    buddy of mine has the same gun. Put a 1000 rounds through it, and the trigger will get VERY smooth.
  3. mxl

    mxl Well-Known Member

    I prefer 600 or 800 grit. Sand in the direction of movement. :)
  4. CZguy

    CZguy Well-Known Member

    Or use a snap cap and just dry fire the heck out of it.
  5. HorseSoldier

    HorseSoldier Well-Known Member

    +1 to the shooters.

    Before I started sanding on anything, I'd try working with it with snap caps and putting a good number of rounds downrange. CZ triggers get better with use. My SP-01 was midly gritty when I bought it, but after several heavy workouts on the range, that grit was pretty much gone.

Share This Page