HELP...disassembled a used Walther G22 how to reassemble ...

Status
Not open for further replies.

usp9

Member
Joined
Dec 17, 2005
Messages
4,000
Location
Bowling Green, Va
How does the bolt catch lever and spring fit back together in the reciever? Also, the mag release button feels different. Does something fall off that too when you disassemble? I didn't see any extra parts. Just put $300 into a used gun for my son and I can't figure out from the manual how things fit back together.:banghead:
 
The parts list I have for the Walther G22 is lost in the pile of papers on my desk so I am not sure which part you are referring to. Maybe these will help.

This is the lever that keeps the rifle from firing without the magazine being inserted.
168051611-M.jpg


This is the lever that holds the bolt open when the magazine is empty.
168051641-M.jpg


Left side internals.
168051673-M.jpg


Right side internals.
168051714-M.jpg


Close up of the mag release.
168051751-M.jpg


Let me know if you need a picture of something else or further explanation.
 
for the mag release check how tight is the stock screw. i found out that screwing it too tight will get the mag stuck - pressing the button felt peculiar and mag was stuck. i fixed it by relieving the pressure to the point where everything started to work normally.

My advise - don't disassemble it, you can clean it with boresnake or flex-rod, small parts are true PITA.
 
These posts were of great help and solved my problems. Thanks for the help. My son shot it today and loved it. He's a lefty and this is his gun.
 
Status
Not open for further replies.
Back
Top