1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

High Power Clone

Discussion in 'Handguns: Autoloaders' started by hoek48, Nov 24, 2006.

  1. hoek48

    hoek48 Active Member

    A co-worker purchased a FEG Mod. MBK-Compact, Serial #K021xx. He wants me to clean it up for him. I know it is not a true HP clone. The grips are cracked/broken. Does anyone know if High Power grips will fit on this weapon. The weapon is a traditional DA/SA with maybe 50% of the finish left and rust but no noticable pitting. He paid approx. $125.00. Thanks for any information.

    edited: I need help to get the slide off of this weapon. The rear of the slide resembles a S&W with the safety on the slide. I can not get the slide stop lever out in order to get the slide off so that I can clean/check the inside of the frame and slide.
    Last edited: Nov 24, 2006
  2. banddr2

    banddr2 Well-Known Member


    I had an FEG Hi Power once, and purchased after market hi power grips and they fit fine. I don't remember enough about takedown to help you out with the slide.

Share This Page