1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Hornady L-n-L power drop problem.

Discussion in 'Handloading and Reloading' started by metalax, Mar 7, 2010.

  1. metalax

    metalax New Member

    Any one else having a problem with new L-n-L model 95100 system powder drop. The case activated power drop keeps loosening in press bushing receiver. After every dozen rounds or so I notice a slight under load change in powder cop reading and I have to give the power dump a little twist. I have changed o-ring and bushing on dump to test but condition persists. This problem seems to be in press housing lock insert or the weight of the whole case activated power drop hanging there. Are the inserts in press housing replaceable? Any advice would be appreciated. Thank You
  2. jbrown13

    jbrown13 New Member

  3. metalax

    metalax New Member

    Thanks a bunch "jbrown13", I did search but your suggested thread is right on target. I love the press, can be a little fussy wit 9mm but best unit I've ever seen. My problem is accessory madness. I just installing my hornady auto case feeder and ordered the new RCBS bullet Feeder Kit. $$$ Should be fast as hell when full auto.
    tx again
  4. macnewbie

    macnewbie New Member

    did you buy the case feeder recently? I have been looking for one for a while, but it's sold out everywhere :(
  5. NRA-Highmaster

    NRA-Highmaster New Member

  6. Rig Magician

    Rig Magician New Member

  7. WV_Vizsla

    WV_Vizsla New Member

    Hey Metalax,
    What powder r u using?
    Is it ball or flake?
    Do you have the small pistol rotor installed?

    My small rotor works perfectly with WSF & #5, not so good with the large flakes of American Select
    If the die continues to twist out.. try teflon tape over the oring or fiber tape two dies together to prevent the twisting.

Share This Page