1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Iver Johnson Sealed Target 8

Discussion in 'Handguns: Revolvers' started by cleardiddion, Nov 5, 2011.

  1. cleardiddion

    cleardiddion Well-Known Member

    So yesterday I walked into one of the local shops here and managed to find a fairly decent condition sealed 8 for a reasonable price.

    Not the prettiest nor the most fancy of wheelguns but I've been itching for one just to have around. Plus, it's dirt cheap to shoot!

    Everything was all and good till I got home and started going through the sop of detail cleaning all my new acquistions. Everything seemed to be going alright till I tried to get the hammer and mainspring back in.

    I just can't seem to get it to work. I can put the mainspring back into the frame and try to push down on the hammer to get it in but that seems to fail. The other thing that I tried to do was to put in the hammer first and try to put in the mainspring; but, what happens then is that the spring hops in between the hammer and sear and actually binds up the mechanism.

    I tried using my google-fu to try to find instructions but only seem to run across threads on how much these things are worth. If any wheelgun gurus would happen to know where a set of disassembly/reassembly instructions are I would greatly appreciate it. Otherwise I guess I go back to the shop and see if they can help put it back together for me (for a fee).

    Thanks greatly in advance!
  2. Carl N. Brown

    Carl N. Brown Well-Known Member

    Is this one of the Model 50 thru 57 series with coil mainspring?
    OR is this one of the earlier models with a flat mainspring?

    For the coil spring model.
    The NRA manual shows small grips with side screw or large grips held by a grip screw that enters the back of the frame. With the grips removed, there is a hole at the lower back of the frame that allows access to the mainspring adjustment screw.
    Reassemble in reverse order. (Yes, that old chestnut is not always helpful, but that's all I have found.)

    Reassembly should be easier if the mainspring adjustment screw is backed out reducing the compression required on the spring when replacing the hammer. Then retension the mainspring by turning the mainspring adjustment screw in.
  3. cleardiddion

    cleardiddion Well-Known Member

    It's the older model with the rounded front sight and with the flast mainspring. And as far as I can see there isn't even a hole for a mainspring adjustment screw much less the actual screw itself.
  4. Carl N. Brown

    Carl N. Brown Well-Known Member

    This is about all I could find showing the Iver Johnson with a flat mainspring (it does not require an adjustment screw). The diagram does show positioning of the flat mainspring in the older model. Hope this helps.

    Attached Files:

  5. Stumper

    Stumper Well-Known Member

    Not to be a smart alec or rain on your parade..... but I find the best detail strip on most revolvers is obtained by removing the grips and sideplate( if applicable) and douse it with brake parts cleaner, cycle and repeat several times then allow to dry and apply a good lubricant. It is possible to flush out all of the crud without disassembly and the inherent problems that may arise in an unfamiliar lockwork.
  6. cleardiddion

    cleardiddion Well-Known Member

    Carl, that's pretty much my revolver with just a slightly different firing pin/hammer configuration.

    This should help a lot!
  7. cleardiddion

    cleardiddion Well-Known Member

    That picture was a lifesaver.
    Turns out that I was trying to put the mainspring in the upside down.

    That's what I get for not researching and then trying to take apart a new gun; then, having springs pop out life one of those joke can snakes.

Share This Page