1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Kahr PM9 owners... a question, please.

Discussion in 'Handguns: Autoloaders' started by spin180, Jul 28, 2007.

  1. spin180

    spin180 Well-Known Member

    Might I trouble one of you fine folks to take a couple of measurements for me?

    I need to know what the length measurement is from the front (outside) of the trigger guard to the muzzle end of the slide, and the the height from the bottom of the dust cover/frame to the top of the slide (in the area of the front sight).

    Many thanks!
  2. The Lone Haranguer

    The Lone Haranguer Well-Known Member

    I have a PM9. Stand by while I get a caliper.

    The trigger guard has a radius where it meets the dust cover, is slanted rearward and has another radius at its corner. At what point do you want to take this measurement?
  3. redneckrepairs

    redneckrepairs Well-Known Member

    I was going to offer to mesure , but it looks like its well in hand lol .
  4. The Lone Haranguer

    The Lone Haranguer Well-Known Member

    From bottom of frame to top of slide behind front sight: 1.455 inches.
    From muzzle end of bottom of slide to beginning of the trigger guard radius: .960 inch.
    From muzzle end of slide to center of front portion of trigger guard: 1.365 inches. (Last two are approximate due to need for "eyeballing.")
    Last edited: Jul 28, 2007
  5. spin180

    spin180 Well-Known Member

    I think about halfway between the upper radius and and the lower radius, where the guard curves back toward the grip, would be alright.

    I really appreciate your help. ;)
  6. The Lone Haranguer

    The Lone Haranguer Well-Known Member

    The third measurement is at this point.
  7. spin180

    spin180 Well-Known Member

    I took so long figuring out what I wanted to say in my previous post that you posted while I was still in process.

    Thanks again for the help.


Share This Page