1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

new alloy... Light cast bullets @ very difficult to cast?

Discussion in 'Handloading and Reloading' started by Reefinmike, Aug 13, 2013.

  1. Reefinmike

    Reefinmike Senior Member

    Apr 17, 2012
    SW Ohio
    thanks for the info 41, maybe ill get to the bottom of this, maybe ill just have to pull my hair out while casting all this up and just deal with it! I didnt really spray em down and I went along, at the end of my casting session, some were still piping hot, most were warm and some were cold. you know how long a pile of freshly cast bullets can stay hot... I just ran some water over them when I was done so I could count/weigh em out right after.

    Depending if this stuff is too hard for my use, im sure I could find people that need superhard lead.

Share This Page