1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

New toy available from LEE

Discussion in 'Handloading and Reloading' started by tackstrp, Apr 3, 2010.

  1. tackstrp

    tackstrp Well-Known Member

    Attached Files:

  2. rcmodel

    rcmodel Member in memoriam

  3. tackstrp

    tackstrp Well-Known Member

    thanks RC ordered the gadget from midway and a lee sizing die. . almost as cheap to just order the three die set.
  4. tackstrp

    tackstrp Well-Known Member

    ran about 50 reloads thru my new Lee Factory taper crimp die. Could feel all of them getting somoothed out. Then tested all on a Wilson case gauge for headspace. Had two that would not seat fully. I plan on saving those and will remove powder primer etc and test on the new lee gadget when it comes in . Golly bum . if it works as i hope, will do all my cases. so would be sized and the bulge taken out. Or so i hoope . Will find out .

    Thanks for the assistance.
  5. ArchAngelCD

    ArchAngelCD Well-Known Member

    I've heard that is a good tool, just remember, the brass might be weaker because of the original bulge and will probably have a shorter reloading life span...
  6. Beelzy

    Beelzy Well-Known Member

    Wow! I predicted the future in that other thread about the .380......LOL!!!
  7. tackstrp

    tackstrp Well-Known Member

    i ran over 500 resized and deprimed tumbled 380 auto brass through the lee bulge buster. Most can push with finger. rest need a bump from the primer arm to push.

    Amazed how many need a bump. sure will have fewer failure to fire or feed.

Share This Page