1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Plastic Brick AR Stock

Discussion in 'Gunsmithing and Repairs' started by backbencher, Dec 10, 2013.

  1. backbencher

    backbencher Well-Known Member

    The afternoon's work:




    The sloped bricks will be glued into the A2 pistol grip (a standard AR-15 part, cost me $3) w/ my favorite volumetric glue - 2-part epoxy, costing more than the pistol grip to begin with. The lower receiver is an Aero blem - ran me $60 & an FBI background check @ a Texas gun show. The rear butt is near stock Mk8, w/ very slight improvements. Now I just have to connect everything together. Likely the bottom beams will be replaced w/ 2 hole 2 x1 Technic bricks, w/ the ubiquitous 10-24 rod running through the holes.

Share This Page