1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Quick Question About Holster for P6/P225...

Discussion in 'Handguns: Autoloaders' started by Rubber_Duck, Dec 9, 2008.

  1. Rubber_Duck

    Rubber_Duck Well-Known Member

  2. isuace

    isuace Active Member

  3. The Lone Haranguer

    The Lone Haranguer Well-Known Member

    From the appearance of the trigger guard retention device, I think the P225, with its more elongated and squared-off trigger guard, would not fit.
  4. rbernie

    rbernie Well-Known Member

    It will not.

    For my P6, I use a CompTac Paddle OWB.
  5. Rubber_Duck

    Rubber_Duck Well-Known Member

    Thanks for the help guys.
  6. Frog48

    Frog48 Well-Known Member

    I also have a similar question...

    Will a Galco Yaqui #YP202 fit a P225/P6?

    I figure that since the same holster fits the P220, P226, and P229, it might. Unfortunately Galco doesnt list the P225/P6 on its model selector.
  7. Daizee

    Daizee Well-Known Member

    the 225 is a single-stack, and if I recall correctly, the 226 and 229 slides are not substantially thinner than the gun frame. Since the frame is wider to accommodate double-stack mags, I'd expect the slides to be thicker too (unless it's a fat-body grip like a para double-stack .45).

    The 225 is quite slim, and the barrel is not extra thick, so I'd expect a 220 holster to be way too big.

    All that being said, I don't have a non-225 sig to compare it to.

    We did happen to find a lefty uncle-mike's kydex paddle for the 225 when my partner bought hers, but she hasn't used it. I made her a leather one instead. Fits perfectly and looks a lot classier. :)

  8. PO2Hammer

    PO2Hammer Well-Known Member


Share This Page