1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Sharpshooter competition trigger.

Discussion in 'Gunsmithing and Repairs' started by ldlfh7, Aug 16, 2014.

  1. ldlfh7

    ldlfh7 Well-Known Member

    Recently installed the competition trigger from sharpshooter supply. All went well but now I cannot insert the bolt. The bolt release button on my savage model 11 cannot be pushed low enough to allow the bolt to be inserted before it hits the sear and stops. Any idea what I did wrong?
  2. ldlfh7

    ldlfh7 Well-Known Member

    Problem fixed.
    Please remove thread.
  3. BBBBill

    BBBBill Well-Known Member

    What did you find?
  4. ldlfh7

    ldlfh7 Well-Known Member

    I reviewed the install instructions and it appeared I had done everything correctly however the trigger sear would not reset far enough to allow the bolt to be put back in. After frustration I took the trigger off and put the bolt into the action. Then I put the trigger assembly back on and like magic the sear was engaging as it should. Not sure why it would not before but all is well now.

Share This Page