1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Tuning A Remmy

Discussion in 'Blackpowder' started by kwhi43@kc.rr.com, Jan 12, 2011.

  1. kwhi43@kc.rr.com

    kwhi43@kc.rr.com Well-Known Member

    Is your hammer too hard to pull back? Wanting a lighter pull, Revolver too
    hard to do fanning? Well here's your answer. Go to VTI parts and order
    part SI01016 after market light main spring for a Uberti SSA Cattleman.
    You will have to shorten it by about 1/16 Just lay it beside your old
    mainspring and see how much to cut off the end that comes in contact
    with the hammer. It will drop right in your Pietta, should work on Uberti
    but I don't know for sure. Works great on Pietta.

  2. Z71

    Z71 Well-Known Member

    I just backed out my strain screw a turn.
  3. kwhi43@kc.rr.com

    kwhi43@kc.rr.com Well-Known Member

    I did too and even put three different 58 Remmy springs in,, but you can't match the new thinner lighter spring. You just got to feel it. You will never
    go back.

Share This Page