Are you going to run a powder cop?
This I am unsure of. I saw one was included in the box.
At first I was thinking about the RCBS Lockout Die, but I don’t want to have to disassemble things to get the press working again. I have no problem just tossing the not quite right case aside until the end.
The Powder Cop might be nice, but it still uses a Mark I eyeball for operation. I’ll be getting nice press lights,(that should come with it) so I’ll be able to see in general, but also into the case. I may not find it as useful. It may be a case to case
thing. Small charges in a larger case might give tinier readings.
I can’t wait to find out!
One thing I know that is both fantastic and frustrating, my location of emplacement is chosen. There isn’t enough stand over height on the basement bench.
While digging enough chest space to insulate the front porch foundation walls of Millpond Manor, I discovered the earth under the concrete floor in the closet I hand planned on turning into my new Handloading Alcove, has been washed away. A two foot cavern is now there and I should move all my ammunition before it becomes subterranean.
So that leaves the Garage.
I’ll just have to live with the truck outside. Since the family room is finished, quite nicely I must say, I’m turning the garage into my new loading room! The whole thing! 24 sq feet to 400! Strangely, I’ll still share it with a water heater, but I have gas line for a heater and a small A/C unit for the one split window.
Finally, a proper ManCave! Climate controlled even.
Unfortunately, that means much more work before this press will be running. There is no bench in there, yet. I anticipated only drilling holes…
Haha, still, I haven’t been this excited to glue Formica to particle board in a while!