Recent content by 1911JAS

What does the manual say? You are going to get alot of different opinions. My self, I clean after each range use. Using the same products for all my non corrosive ammunition. Amsoil MP, Mobil 1 oil, and Mobil grease.

What do you plan on using it for? I have had good success with Sierra 168 match king, using 284 brass.

I have a first gen M9. It has been a reliable shooter. I shoot alot of cast bullets with shot gun powder and have not had any isues. Mine has the silly lock on the side that takes a handcuff key. It fits my hand well and is comfortable. It rings steel at 50 ft and my shooting buddies enjoy it as...

Welcome

Some of what I picked up in 2022, Savage 720 Astra 600 SA 35 Sig P210 Mossberg 144

For my lee dies I remove the o-ring and drill and tap the side of the aluminum nut for a 6-32 set screw. Then thread the nut on the die. I put a #4 lead shot in the taped hole then the set screw. When I have put the die in my press and have a final location of the locking ring. I tighten the set...

I have an opportunity to get a Savage 720 12ga for $225. Sorry I do not have any pictures. The barrel appears to have been re-blued, the receiver retains about 20% of its original finish. I did not see any rust or pitting. The wood stock and forend do not have any cracks. Mechanical it's in...

OGCA?

You might try liberty tree collectors. I see the hand guard for sale.

Hope this weekend to sight in my Knight mk85 with a new 2.5-7 scope.

I started in 1995 with a MEC jr to support my trap shooting. Then I got a rockchucker to start reloading 38 special. Well... 20+ cartridges, 3 gauges, and too much equipment later I am still going strong. Happy reloading.

I have 2 RCBS trim pro. They work well for me.

Alot of good talk about presses. Some new, some old. I too have a RC that is setup with a piggyback for pistol. I have not heard any talk about the old RCBS A2. I found my first at a gun show in the early 90's. I must be the only one who prefers to load rifle on an A2. Still on the lookout for...

Or are you saying the last 20% of work? The best option is a mill, digital readout, and all the required tooling.

I have a BL22 and remember the first time I took it apart. I had the same issue with that small spring. I uses a little nail polish to hold the spring in its little pocket. Glad to hear you got it back together.