Recent content by 1stTimer3Gun

Sorry - I've been meaning to get back to you Loco. I'm not sure what division to go with yet. Right now I have a 1.5-6 MTAC scope on my AR, but when I look thru it I don't get a good cheek weld which is why I'm looking into getting a red dot. I doubt that I'll be shooting much past 100 yds...

Thanks rc. That's what I was trying to figure out.

Hi While I know what MOA stands for, what I don't get is when I'm reviewing what kind of optics (red dot for an ar15) to get what it means when one optic has a low number like 3 MOA another one has 8 MOA. Is a low number better than a higher number? I looking to use it in competition...

Yeah, I'm not spending 200 bucks on something like that. I was actually starting think along the same lines as you in buying a mouse pad or two and seeing what I can do with that.

Yes I plan on using it for 3 gun. Sorry Tim, that mount with the Bushnell is going to be too high. I want something lower than that.

Hi all, What's a good red dot for a stag 3g for less than $150? J

Hi everyone, So I have a Stag 3G with a Burris MTAC 1.5-6 scope mounted on a PEPR mount. The issue I have is while I can see down the scope, I don't quite get the proper cheek weld. Does anyone know of a cheek riser that would work on a magpul acs stock? or should I just get a different...

I was kind of leaning towards getting a PEPR mount, but then I read a review that it might be a little heavy. I want to try to be as light as I can.

Hey y'all How do you know what kind of a mount or rings to use? I need to put a Burris MTAC scope on a Stag 3G. -j

Thanks for all the comments and tips. Only time will tell.

I have the Mossberg 930 JM Pro.

Yeah I started to think that I needed to get this and that, then I realized just get something on there and see how I like it. I can always change it up later. It's easy to get bogged down when there's so much stuff out there which kind of leaves you with wanting to have everything when...

I went with the 1-6.

Thanks to all of the suggestions. After some research I have decided to go with the Burris MTAC. One of the things that I noticed in my research is that are some scopes with a red dot on top. Has anybody used this method? Especially in 3 gun? Pros/Cons?

Has anyone used a Barska scope on their AR's? If so, how did it perform? If not, what kind of optics would you use on a Stag 3G? I'm hoping to keep my price under $500 if I can and hoping to get into 3 gun competitions. Any assistance would be greatly appreciated. Thx